Farmhand Nylon Water Bowl

$64.95

Ships in approximately 3 days*.

1 Reviews

Details

The Farmhand Nylon Water Bowl achieves the benefits of several other water bowls. Fully resistant to corrosion in any water, the plastic bowl is livestock-friendly. A hinged stainless steel lid allows for easy access to float assembly. Drain incorporated. Spare valve seal supplied. NB: Not suitable for water pressure over 55 p.s.i. Use to water stock on roadsides, or strip grazing away from a trough (place just under electric wire), or for watering calf pens or stock yards (ideally place in a corner). Mount on a post or rail - there are mount holes in the rear. 15mm (_”) water fittings. Most of the livestock water bowls are designed to slope forward when mounted on a vertical surface. This is to cause the water to run to the front to be used by stock, reducing possible stagnating. The float angle should be adjusted so water fills nearly to overflow at the front edge of the bowl. Capacity: 4 litres. Dimensions: 28cm L x 28cm W x 12cm D. Replacement float assembly and valve rubber available. See separate entry.

Ratings & Reviews

1 review

4

Small criticism

by

From Gabbadah, Western Australia

We have one of these on the house tank. Previous owners installed it for their dogs. We just use it for bird bath & water. I knew that the float was a bit stiff & was inclined to hold the valve open or closed. When I pulled the valve out to repair. I found that the pivot pin for the float was steel & had rusted, causing the valve to stick closed. The pivot pin should be stainless steel. Wouldn't cost much more.